WW1 F.E.8. Propeller Tip , recovered .

WW1 F.E.8. Propeller Tip , recovered .

WW1 F.E.8. Propeller Tip , recovered .

£295.00

In stock

Views: 627

£295.00

WW1 F.E.8. Propeller Tip

Availability: In stock

Description

This is a recovered piece , This is a wingtip from a F.E.8 propeller from the scout/fighter of the First War. This piece is 37 inches in length. most of the brass propeller edge is still present. This is from a crashed aircraft due to the fact that this was used as a grave marker at some point in it’s life, there are two broken off screw ends high up as can see from photo’s, where the name plaque would have been.  and it’s obviously been stood up in the ground as can see the stain mark to the broken end. I’m afraid i don’t have anymore history . The brass i will not clean up because it takes the importance away from this piece.

 

The Royal Aircraft Factory F.E.8 was a British single-seat fighter of the First World War designed at the Royal Aircraft Factory. It could not escape the drag penalty imposed by its tail structure and was no match for the Albatros fighters of late 1916.

Design and development

Royal Aircraft Factory F.E.8

The F.E.8 was an early British “scout” aircraft, designed from the outset as a single-seat fighter. In the absence of a synchronization gear to provide a forward firing machine gun for a tractor scout such as the S.E.2, it was given a pusher layout.

On the whole the new design, produced by a team led by John Kenworthy followed the conventional “Farman” layout, as did the competing Airco DH.2 designed by Geoffrey de Havilland, who had also previously worked at the Royal Aircraft Factory – but it had some novel features.[1]

The nacelle was an all-metal structure – being framed in steel tube and covered with duralumin. The prototypes were fitted with large streamlined spinners on the propeller hub, although these were soon removed, and the production F.E.8s were built without them. The wings had a narrow chord, giving them a high aspect ratio. They featured dihedral outboard of the wide centre section, and the ailerons were of unusually long span – occupying the entire wing trailing edge outboard of the tail booms. The booms themselves were attached to the main spar of the tailplane, rather than the rudder post, giving them taper in side elevation rather than in plan, as was done with the DH.2. This allowed the fitting of a variable incidence tailplane, although this was not adjustable in flight, but only on the ground. A single 100 hp (75 kW) Gnome 9 “Type B2” Monosoupape rotary engine driving a four-bladed propeller powered the aircraft,[2] with the capability of taking the lower-powered Le Rhône 9C 80 hp (60 kW) nine-cylinder rotary.

Its first flight was made on 15 October 1915 and the test pilot was satisfied with the aircraft’s handling. The aircraft was then armed with a single Lewis gun, which was originally fitted on a movable mount within the nose of the nacelle, with the machine gun’s breech almost at the pilot’s feet. This proved awkward in practice, and in production machines the gun was mounted directly in front of the pilot, in the manner of the D.H.2. Other changes required before the aircraft entered production included extra fuel to counter criticism from the commander of the Royal Flying Corps in France, Hugh Trenchard, that the F.E.8’s endurance was too short.[3] The new fighter was not a great improvement on the D.H.2 – although a little faster it was rather less manoeuvrable. It was nonetheless ordered into production from Darracq Motor Engineering Company and Vickers. Neither manufacturer delivered their F.E.8s particularly quickly, so that the type only reached the front in any numbers six months after the D.H.2.[4]

Operational history

Royal Aircraft Factory F.E.8 in service

The second prototype had a spinner mounted when it was sent to No. 5 Squadron RFC at Abeele for evaluation on 26 December 1915, but had been removed by January 1916. It became the nearly exclusive mount of Captain Frederick Powell.[5]

A few early production F.E.8s were briefly used by No. 29 Squadron RFC alongside its DH.2s in June 1916, but it was not until August that No. 40 Squadron became fully operational on the type. The only other unit to be completely equipped with the type, No. 41 Squadron, arrived in France in October.[6][7]

After a fairly good start, the F.E.8 units quickly ran into problems with the new German fighters. The only ace on the type was Edwin Benbow who was credited with shooting down a German fighter on 6 March 1917, probably that of Manfred von Richthofen, who force landed with a holed fuel tank and narrowly escaping incineration.[8]

Just three days later, on 9 March, 40 squadron was again involved with Jagdstaffel 11, when nine F.E.8 were engaged by five Albatros D.IIIs led by Richthofen. Four F.E.8s were shot down, four others badly damaged, and the survivor caught fire when landing.[9] After this disaster No. 40 Squadron was re-equipped with Nieuport 17s but No. 41 kept their pushers until July 1917 – becoming the last single-seat pusher fighter squadron in France, using them for ground attack duties during the Battle of Messines.[10]

Two F.E.8s were sent to Home Defence units in 1917, but the type was not adopted as a home defence fighter.[10]

    • Specifications (F.E.8 (Gnome engine))

RAF F.E.8 3-view drawing

Data from The Royal Aircraft Factory[11]

At this time, Antiqurio ships to locations within the United Kingdom mainland. Items can be shipped worldwide by prior agreement please contact us. The risk of loss and title for all items ordered on this website pass to you when the items is delivered to the shipping carrier. We are unable to calculate shipping automatically for multiple items when shipping internationally please contact us by email if you wish to purchase more than one item and live outside of the UK; we are working to resolve this

International

Customs and import duties may be applied to International orders when the shipment reaches its destination. This is not imposed by Antiqurio and these charges are the responsibility of the recipient of your order and are likely to vary from country to country. Contact your local customs office for details.

Shipping laws are different in each country. It is your responsibility to check with your Customs office to verify whether the country to which you are shipping permits the shipment of your products. Antiqurio is not responsible for any direct, indirect, punitive, or consequential damages that arise from improper international shipping practices.